Welcome to a new voltlog, today we’re going to be talking about this little board which I designed and assembled myself, it’s a breakout module for the FTDI FT232H which is a usb to serial converter but with a nice twist. This particular chip from FTDI has the built-in Multi-Protocol Synchronous Serial Engine (MPSSE short) which allows you to run a variety of synchronous serial protocols like JTAG, I2C, SPI or simple bit-banging of IOs. You can imagine it can be really useful to be able to interface with a sensor over I2C or SPI straight from your computer over USB through this interface. You wouldn’t need an arduino or other controller in the middle if you plan to do some data acquisition for example.
Tag: SMT
Voltlog #262 – Is This The Future of Our Hobby?
To be honest I didn’t think we were going to have services like these available so cheap so fast. I mean yes I know pcb prices have been so low in the past couple of years that it no longer makes sense to etch your own PCBs, unless you are in a big hurry. But having smt assembly service so cheap? Soon enough it would not make sense to hand assemble these boards because it would be equally cheap to have them assembled at JLCPCB
Voltlog #256 – Best BST-863 Hot Air Rework Station (Alternative to Quick 861DW)
Inside the box of the BST-863 we have the station, a really nice and heavy stand for the tool piece, a total of 3 nozzles, a grounding strap and a power cord. The first thing I notice is the hose which pretty thick, certainly thicker than what I had on my old Gordak station but seems to be softer material. The way it’s designed with the tool standing vertically in the stand makes the air hose forms this loop which depending on your bench setup might or might not bother you but it’s something to consider. But I like the quality of the stand, it’s heavy and feels very sturdy, you get this accessory here which allows you to remove the nozzles while hot and the station has a sensor to detect when the handle is in the stand.
Adjustment of temperature and air level is made through this touch screen control. I’m a bit anti touch screen control on test gear so I would’ve preferred some switches on the front panel but don’t get me wrong, the touch screen works well on this unit, it has nice big touch keys and after setting up your presets you are likely not going to need to adjust the temperature you will just be using the presets like leaded, lead free and another one for heatshrink maybe.
Is this cheaper station a good alternative to the Quick 861DW? This video review should provide you with enough info to decide which one to buy.
Here are some high resolution images from the teardown:
Voltlog #251 – InTheMail
Welcome to a new InTheMail, the series that will touch both your passion for electronics and your bank account at the same time. We’re going to start with this pocket multimeter, it’s the MUSTOOL MT77, let’s get it out of the box. As you can see quite a small form factor, the multimeter is very thin and has this large screen to body ratio, let’s see if they included the batteries and yes the meter turns on, it runs on two CR2032 batteries but it seems they are included.
Voltlog #35 – SMD Assembly And Reflow
In this video I am going to show you how I assemble PCBs with surface mount devices. First I apply the solder paste with the help of a stainless steel laser cut stencil, next I manually pick and place all the components and the last step is to run the boards through a reflow profile in my DIY reflow oven.